IBM System x3650 M4 Type 7915 Problem Determination And Service Manual page 59

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
v Go to the IBM support website at http://www.ibm.com/supportportal/ to check for technical information,
hints, tips, and new device drivers or to submit a request for information.
Diagnostic
code Message
S.2011001 [S.2011001] An
Uncorrected PCIe Error
has Occurred at Bus %
Device % Function %.
The Vendor ID for the
device is % and the
Device ID is %.
S.2018001 [S.2018001] An
Uncorrected PCIe Error
has Occurred at Bus %
Device % Function %.
The Vendor ID for the
device is % and the
Device ID is %.
I.2018002 [I.2018002] The device
found at Bus % Device
% Function % could
not be configured due
to resource constraints.
The Vendor ID for the
device is % and the
Device ID is %.
I.2018003 [I.2018003] A bad
option ROM checksum
was detected for the
device found at Bus %
Device % Function %.
The Vendor ID for the
device is % and the
Device ID is %.
Description Action
PCI SERR Detected.
1. Check the riser-card LEDs.
2. Reseat all affected adapters and riser cards.
3. Update the PCI adapter firmware.
4. Replace the affected adapters and riser cards
5. (Trained technician only) Replace the system
PCIe Uncorrected Error
1. Check the riser-card LEDs.
Detected.
2. Reseat all affected adapters and riser cards.
3. Update the PCI adapter firmware.
4. Replace the affected adapters and riser cards
5. (Trained technician only) Replace the system
OUT_OF_RESOURCES
1. Run the Setup utility (see "Using the Setup
(PCI Option ROM).
2. Informational message that some devices
3. See retain tip H197144 http://www-
ROM CHECKSUM
1. Check the riser-card LEDs.
ERROR.
2. Reseat all affected adapters and riser cards.
3. Move the affected adapter to a different slot.
4. Update the PCI adapter firmware.
5. Replace the affected adapters and riser cards
(see "Removing a PCI adapter from a PCI
riser-card assembly" on page 221 and
"Installing a PCI adapter in a PCI riser-card
assembly" on page 222).
board (see "Removing the system board" on
page 290 and "Installing the system board"
on page 292).
(see "Removing a PCI adapter from a PCI
riser-card assembly" on page 221 and
"Installing a PCI adapter in a PCI riser-card
assembly" on page 222).
board (see "Removing the system board" on
page 290 and "Installing the system board"
on page 292).
utility" on page 301). Select Startup Options
from the menu and modify the boot sequence
to change the load order of the
optional-device ROM code.
might not be initialized.
947.ibm.com/support/entry/portal/
docdisplay?lndocid=migr-5084743 for more
information.
(see "Removing a PCI adapter from a PCI
riser-card assembly" on page 221 and
"Installing a PCI adapter in a PCI riser-card
assembly" on page 222).
Chapter 3. Diagnostics
41