IBM System x3650 M4 Type 7915 Problem Determination And Service Manual page 322

v Boot Manager
v System Event Logs
v User Security
v Save Settings
304
IBM System x3650 M4 Type 7915: Problem Determination and Service Guide
Wake on LAN functions. For example, you can define a startup sequence that
checks for a disc in the CD-RW/DVD drive, then checks the hard disk drive, and
then checks a network adapter.
This choice is on the full Setup utility menu only.
Select this choice to view, add, delete, or change the device boot priority, boot
from a file, select a one-time boot, or reset the boot order to the default setting.
Select this choice to enter the System Event Manager, where you can view the
error messages in the system event logs. You can use the arrow keys to move
between pages in the error log.
The system event logs contain all event and error messages that have been
generated during POST, by the systems-management interface handler, and by
the system service processor. Run the diagnostic programs to get more
information about error codes that occur. See "Running the diagnostic programs"
on page 137 for instructions on running the diagnostic programs.
Important: If the system-error LED on the front of the server is lit but there are
no other error indications, clear the IMM2 system-event log. Also, after you
complete a repair or correct an error, clear the IMM2 system-event log to turn off
the system-error LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST error
messages.
– System Event Log
Select this choice to view the IMM2 system event log.
– Clear System Event Log
Select this choice to clear the IMM2 system event log.
Select this choice to set, change, or clear passwords. See "Passwords" on page
305 for more information.
This choice is on the full and limited Setup utility menu.
– Set Power-on Password
Select this choice to set or change a power-on password. For more
information, see "Power-on password" on page 305 for more information.
– Clear Power-on Password
Select this choice to clear a power-on password. For more information, see
"Power-on password" on page 305 for more information.
– Set Admin Password
Select this choice to set or change an administrator password. An
administrator password is intended to be used by a system administrator; it
limits access to the full Setup utility menu. If an administrator password is set,
the full Setup utility menu is available only if you type the administrator
password at the password prompt. For more information, see "Administrator
password" on page 306.
– Clear Admin Password
Select this choice to clear an administrator password. For more information,
see "Administrator password" on page 306.
Select this choice to save the changes that you have made in the settings.