IBM System x3650 M4 Type 7915 Problem Determination And Service Manual page 62

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
v Go to the IBM support website at http://www.ibm.com/supportportal/ to check for technical information,
hints, tips, and new device drivers or to submit a request for information.
Diagnostic
code Message
W.305800A [W.305800A] DRIVER
HEALTH PROTOCOL:
Reports 'Failed' Status
Controller.
W.305800B [W.305800B] DRIVER
HEALTH PROTOCOL:
Reports 'Reboot'
Required Controller.
W.305800C [W.305800C] DRIVER
HEALTH PROTOCOL:
Reports 'System
Shutdown' Required
Controller.
W.305800D [W.305800D] DRIVER
HEALTH PROTOCOL:
Disconnect Controller
Failed. Requires
'Reboot'.
W.305800E [W.305800E] DRIVER
HEALTH PROTOCOL:
Reports Invalid Health
Status Driver.
44
IBM System x3650 M4 Type 7915: Problem Determination and Service Guide
Description Action
DRIVER HEALTH
1. Restart the system.
PROTOCOL: Reports
2. If the problem persists, switch to the backup
'Failed' Status
Controller.
3. (Trained technician only) Replace the system
DRIVER HEALTH
1. No action required. The system will reboot at
PROTOCOL: Reports
'Reboot' Required
2. If the problem persists, switch to the backup
Controller.
3. (Trained technician only) Replace the system
DRIVER HEALTH
1. Restart the system.
PROTOCOL: Reports
2. If the problem persists, switch to the backup
'System Shutdown'
Required Controller.
3. (Trained technician only) Replace the system
DRIVER HEALTH
1. Restart the system.
PROTOCOL:
2. If the problem persists, switch to the backup
Disconnect Controller
Failed. Requires
'Reboot'.
3. (Trained technician only) Replace the system
DRIVER HEALTH
1. Restart the system.
PROTOCOL: Reports
2. If the problem persists, switch to the backup
Invalid Health Status
Driver.
3. (Trained technician only) Replace the system
UEFI image or reload the current UEFI
image.
board (see "Removing the system board" on
page 290 and "Installing the system board"
on page 292).
the end of POST.
UEFI image or reload the current UEFI
image.
board (see "Removing the system board" on
page 290 and "Installing the system board"
on page 292).
UEFI image or reload the current UEFI
image.
board (see "Removing the system board" on
page 290 and "Installing the system board"
on page 292).
UEFI image or reload the current UEFI
image.
board (see "Removing the system board" on
page 290 and "Installing the system board"
on page 292).
UEFI image or reload the current UEFI
image.
board (see "Removing the system board" on
page 290 and "Installing the system board"
on page 292).