Removing The Copyboard Cover Open/Close Sensor (Front/Rear); Contact Sensor Hp Sensor; Removing The Copyboard Glass; Removing The Adf Reading Glass - Canon iR2020 Series Service Manual

[3]
[5]
When installing the ADF harness [4], fit the harness band [5] in the
groove in the reader rear cover.
5) Remove the four screws [1], and then detach the reader rear cover [2].
4.4.5.6 Removing the Copyboard Cover Open/Close
Sensor (Front/Rear)
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Disconnect the to connectors [1], and then remove the screw [2].
2) Remove the reusable band [3], and then remove the harness [4] from the
sensor mount.
3) Remove the sensor mount [5].
4) Remove the sensor from the sensor mount.
[5]
[2]

4.4.6 Contact Sensor HP Sensor

4.4.6.1 Removing the Copyboard glass

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the copyboard cover (or ADF).
2) Remove the two screws [1], remove the glass retainer [2], and then
[2]
[1]
[4]
F-4-82
[1]
[2]
F-4-83
[1] [4]
[3]
F-4-84
remove the copyboard glass [3].
When removing the copyboard glass, take care not to touch the
following:
- Glass surface
- Standard white plate
Dirt on these parts can show up as white/black lines in the image. If dirt is
found, remove it with lint-free paper moistened with alcohol.
0010-4310

4.4.6.2 Removing the ADF Reading Glass

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the copyboard cover (or ADF).
2) Remove the two screws [1], and then remove the glass retainer [2].
3) Remove the ADF reading glass [3].
0010-6113
[3] [1]
[2]
F-4-85
F-4-86
F-4-87
Chapter 4
0010-6114
4-25