Making Preparations; Registering The System Software - Canon iR2020 Series Service Manual

Chapter 15
When using the SST, select "#DOWNLOAD" in the service mode to place the main unit in the download mode. (The finisher need not enter the download mode.)

15.2 Making Preparations

15.2.1 Registering the System Software

iR2016J / iR2016 / iR2020 /
System software programs to be downloaded need to be registered in the SST.
The system software programs are registered with the names listed below.
<Software Programs Preinstalled in Main Unit>
Machine name:iR2020
Unit name:
- Main controller: System
- Boot program: Boot
- PCL board: PCL
The system software registration program is explained below taking System as an example.
[Preparation]
Have the following ready:
- PC in which SSTv3.21 or later is installed
- System CD supplied with iR2020
[System Software Registration Procedure]
1) Start the PC.
2) Insert the system CD in the PC.
3) Start SST.
4) Click the "Register Firmware" button.
15-2
Main unit
Image processor PCB
16MB ROM
Flash ROM CPU
16MB ROM PCB
Flash ROM
USB Memory
Flash Memory
Finisher-U1
Finisher controller PCB
Flash ROM
CPU
USB cable
J303
RS232C
straight cable
Downloader
PCB
FY9-2034
J918
F-15-2
PC
SST
System
software
0011-1866