Fixing Film; Removing The Drum Unit; Removing The Rear Cover; Removing The Left Cover (Rear) - Canon iR2020 Series Service Manual

[3]
When installing the pressure roller, bring the ground plate [4] into contact
with the roller shaft [5].

8.4.3 Fixing Film

8.4.3.1 Removing the Drum Unit

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover [1].
2) Turn the developing assembly locking lever [2] clockwise to open the left
door [3].
3) Draw out the drum unit [4].
[4]
[3]
[2]
- When attaching or detaching the drum unit, open the left door fully to pre-
vent the damage to the drum unit.
- To prevent exposure of the drum, cover the drum unit with a few sheets of
paper and place it in a safe place.

8.4.3.2 Removing the rear cover

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then detach the rear cover [2].
[2] [1]
F-8-43
[4] [5]
F-8-44
[1]
F-8-45

8.4.3.3 Removing the Left Cover (Rear)

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the three screws [1], and then detach the left cover (rear).
[2]
[1]

8.4.3.4 Removing the Left Door

0010-9923
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the screw [1] securing the door support band. Remove the
connector [2] and reusable band [3], and release the duplex unit harness
from the wire saddle [4].
[2]
0010-9924
2) Open the left door until it sops and pull out the hinge shaft [1].
MEMO:
When a duplex unit (option) is installed, remove it before pulling out the
hinge shaft for each access.
Chapter 8
[1]
[2]
[1]
F-8-46
F-8-47
[1]
[3] [4]
F-8-48
0010-9925
0010-9926
8-13