Installing The Control Card Cable; Preparing The Parts - Canon iR2020 Series Service Manual

2.9 Installing the Control Card Cable

2.9.1 Preparing the parts

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Prepare the following parts.
[1]
[1] Control card cable
[2] Binding screw (M4x6)

2.9.2 Installing the Control Card Cable

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Turn off the main power switch [1] of the host machine and disconnect the
power plug [2] from the outlet.
2) Remove the 4 screws, and then detach the rear cover [1].
3) Connect the connector of the control card cable [1] to the connector J320
[2] on the image processor PCB.
4) Using the binding screw (M4x6) [1], secure the control card cable clamp
[2].
[2]
F-2-114
1 pc.
1 pc.
[2]
[1]
F-2-115
[1]
F-2-116
[1]
[2]
F-2-117
0012-4187
5) Using a nipper, remove the precut portion [1] of the rear cover as shown
below.
0012-4195
6) Attach the rear cover with the control card cable routed through the cut
portion [1] of the rear cover.
7) Continue work for the control card.
Chapter 2
[2] [1]
F-2-118
[1]
F-2-119
[1]
F-2-120
2-45