Removing The Original Sensor (Vertical Scan Direction) (Ir2020/Ir2020J/Ir2020I); Removing The Original Sensor (Horizontal Scan Direction) (Ir2020/Ir2020J/Ir2020I) - Canon iR2020 Series Service Manual

4.4.7.2 Removing the Original Sensor (Vertical Scan
Direction) (iR2020/iR2020J/iR2020i)
iR2020 / / iR2020i
1) Remove the screw [1], and then detach the cover [2].
[2]
2) Disconnect the flexible cable [1], remove the screw [2], and then detach
the cover [3].
3) Pull the drive belt (front) [4] in the direction of the arrow to move the
contact sensor [5] to the left.
F-4-92
F-4-93
[1]
F-4-94
[5]
4) Disconnect the connector [1], and then remove the harness from the edge
saddle/clamp [2].
5) Remove the three screws [3], and then remove the original sensor (vertical
scan direction) [4] together with the mount.
6) Disconnect the connector [1], and then remove the original sensor
(vertical scan direction) [2].
0010-4317
[1]
4.4.7.3 Removing the Original Sensor (Horizontal Scan
Direction) (iR2020/iR2020J/iR2020i)
iR2020 / / iR2020i
1) Remove the screw [1], and then detach the cover [2].
[3] [2]
[4]
F-4-95
[2] [1]
[4]
F-4-96
[2]
F-4-97
Chapter 4
[1]
[3]
0010-6116
4-27