Removing The Multifeeder Unit; Removing The Multifeeder Pickup Solenoid; Registration Roller; Removing The Drum Unit - Canon iR2020 Series Service Manual

7.5.9.5 Removing the Multifeeder Unit

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then remove the multifeeder unit [2].
[2]
[1]

7.5.9.6 Removing the Multifeeder Pickup Solenoid

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Disconnect the connector [1], and then remove the harness from the guide.
2) Remove the screw [2], and then remove the multifeeder pickup solenoid
[3].
[3]
[2]
[1]
F-7-46
F-7-47
[2] [1]
F-7-48

7.5.10 Registration Roller

7.5.10.1 Removing the Drum Unit

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover [1].
2) Turn the developer pressure release lever [2] clockwise, and then open the
left door [3].
3) Draw out the drum unit [4].
[3]
[2]
0011-1050
To prevent exposure to light, cover the drum with several sheets of copy
paper and place it in a safe place.
Open the left door fully to prevent the damage to the drum unit

7.5.10.2 Removing the Registration Roller

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the two screws [1], remove the two metal plates [2], and remove
the registration roller [3].
0011-1052
[1] [2]

7.5.11 Registration Clutch

7.5.11.1 Removing the Rear Cover

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then detach the rear cover [2].
[4]
[1]
F-7-49
[3]
[3] [1] [2]
F-7-50
Chapter 7
0011-2969
0011-0677
0011-0665
7-15