Error Code Table; List Of Error Codes; Error Code Details - Canon iR2020 Series Service Manual

13.1 Error Code Table

13.1.1 List of Error Codes

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i

13.2 Error Code Details

13.2.1 Error Code Details
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
MEMO:
In case of iR2020i/iR2016i, the detail code of the error code of this machine can be confirmed in the following service mode.
Service mode>ERROR DISPLAY
E000
Detail
Error Code
Code
E000 0000 Fixing temperature abnormal rise
0000 Fixing unit temperature rise detection (by main thermistor)
E001
0001 Fixing unit temperature rise detection (by sub thermistor)
E002 0000 Fixing unit temperature insufficient rise
0000 Low fixing temperature detection after standby (by main thermistor)
E003
0001 Low fixing temperature detection after standby (by sub thermistor)
E007 0000 Fixing film rotation error
E010 0000 Main motor rotation error
0001 Waste toner full detection
E019
0002 Waster toner full detection sensor failure
E052 0000 Duplex unit connection error
E100 0000 BD cycle out of range
E197 0000 Erroneous communication with printer engine
E500 0001 Finisher communication error
E520 0000 Offset error
E531 0000 Stapling error
0001 Paper surface not detected (standard tray)
0002 Not moved within the specified time (standard tray)
E540
0003 Sensor not reached within 3 seconds (standard tray)
0005 Encoder clock failure (standard tray)
0001 Paper surface not detected (optional tray)
0002 Not moved within the specified time (optional tray)
E542
0003 Sensor not reached within 3 seconds (optional tray)
0005 Encoder clock failure (optional tray)
E575 0000 Stack delivery error
E584 0000 Shutter failure
E716 0000 Erroneous communication with optional cassette
0000 Erroneous communication with card reader (serial communication)
E719
0002 Erroneous communication with coin vender (serial communication)
E733 0000 Erroneous communication between controller and printer
E736 0000 CCU communication error
E739 0000 Erroneous communication between controller and network board
0001 Language file/boot ROM/USB memory error
0002
E744
0003
0004
E805 0000 Fan failure
E808 0000 Fixing drive circuit failure
Display
Detail Code Main Cause/Symptom
Code
0000 Startup error
The temperature detected by the main
or sub thermistor does not rise to the
specified value during startup control.
T-13-1
Error Name/Explanation of Error
T-13-2
Countermeasure
- Check the fixing film connector.
- Replace the fixing film unit.
- Replace the DC controller PCB.
Chapter 13
0011-2570
0011-2580
13-1