Removing The Reader; Removing The Adf Reading Glass; Removing The Reader Heater (Left) - Canon iR2020 Series Service Manual

[2]
2) Remove the screw [1].
3) Disconnect the connector [2], disconnect the harness from the wire saddle
[3], and then remove the reader heater (right) [4].
[4]
4.4.8.3 Removing the Reader Front Cover
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the copyboard cover (or ADF).
2) Remove the two screws [1], and then detach the reader front cover [2].

4.4.8.4 Removing the ADF Reading Glass

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the copyboard cover (or ADF).
2) Remove the two screws [1], and then remove the glass retainer [2].
3) Remove the ADF reading glass [3].
[1]
F-4-104
[2] [3] [1]
F-4-105
[1]
[2]
F-4-106
- When removing the ADF reading glass, take care not to touch the glass
surface. Dirt on these parts can show up as white/black lines in the image.
If dirt is found, remove it with lint-free paper moistened with alcohol.
- When installing the ADF reading glass, position the cut portion [1] of the
ADF reading glass sheet at the front-left corner.
0010-6118

4.4.8.5 Removing the Reader Heater (Left)

iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the screw [1], and then remove the jump board [2].
0010-6120
2) Remove the two screws [1], and then remove the stream reading glass stay
[2].
3) Pull the drive belt (front) [3] in the direction of the arrow to move the
contact sensor [4] to the center.
[1]
[2] [3]
F-4-107
[1]
F-4-108
[1] [2]
F-4-109
Chapter 4
0010-4321
4-29