System Integration - Gpio Connector; Power Connection - Christie DS+60 User Manual

2.5 System
Integration -
GPIO Connector
2.6 Power
Connection
Regardless of how it is assigned, once a projector has a valid and unique address it
will respond to commands sent to this address. To determine the projector's current IP
address, consult the Status or Communications menus.
Refer to Section 3 for further information about setting up and using a projector
connected via Ethernet.
Log on to www.christiedigital.com for detailed information on ChristieNET.
The GPIO (General Purpose Input Output) connector on the input panel can be used
to provide a method of interfacing a wide range of external I/O devices to the
projector.
Refer to Appendix E: System Integration for complete details on pin configuration
and how to program the various pins on the connector.
Plug the line cord to the AC receptacle located on the right hand side of the projector
and the 3-pronged end into a grounded AC outlet (Figure 2.17). The input voltage to
the projector must be capable of 100 – 240 VAC. (See also Section 6 – Specifications
for complete details on all power requirements.)
Each projector is provided with the North American and European rated line cords.
Make sure you are using the appropriately rated line cord for your area.
Always power down the projector before unplugging the AC line cord – Once you
power down, wait 2 minutes to allow the main exhaust fan to turn off and for the
lamps to cool before unplugging the projector.
Do not attempt operation if the AC supply and cord are
not within the specified voltage and power range.
Wait for the cooling fans to turn off before unplugging the
Section 2: Installation and Setup
WARNINGS
projector.
Figure 2.17.
Christie DS+60 User's Manual 2-17