Using The Hard Disk Drive For Secure And Proof Jobs; Creating Secure Jobs - Xerox DocuPrint N24 System Administrator Manual

Using the Hard Disk Drive for Secure and Proof Jobs

Using the Hard
Disk Drive for
Secure and Proof

Creating Secure Jobs

5-8 DocuPrint N24, N32, and N40 System Administrator Guide
Secure, collate copy, and proof jobs that have been
submitted to the printer are stored in PCL or PostScript
format on the Hard Disk Drive. These secure and proof
jobs can be printed (or deleted) through the Password
Menu where you enter the 4-digit password for the job or
jobs to be printed. Procedures for printing or deleting
Jobs
secure jobs are listed in Table 3.6 on page 3-19.
The secure or proof job is placed at the top of the print
queue, and will print following completion of the
currently printing job. If more than one job is requested,
jobs are placed on the print queue in the order requested.
Secure or proof jobs having the same priority are printed
on a first in, first out basis.
Secure printing delays printing of a job until a password
associated with the job is entered at the printer's Control
Panel. Entering the password at the Control Panel will
provide access to only those jobs send with that password.
Secure jobs are normally created in PCL and PostScript
by choosing the feature in a driver. When not using a
driver, secure jobs may be created by preceding the job
with the following PJL commands:
@PJL XSECUREJOB
@PJL XJOBPASSWORD = "number"
These commands must be immediately followed by a
standard PJL "JOB" command that includes the
"jobname."