End Of Paper Feed; Rel Lever Is In Wrong Position; Rewinding Error - Canon iPF8400 Basic Manual

iPF8400
Cause
There are sheets left on the
Ejection Guide.
There is a foreign object by
the Output Tray, obstructing
the Cutter Unit.
You are not using the printer
under the recommended envi-
ronmental conditions for the
paper.
You are using paper that is
not compatible with automatic
cutting.
In other cases, the Cutter Unit
may be damaged.

End of paper feed.

End of paper feed.
Although an attempt was made to advance the paper manually, it reached the
limit position that can be advanced.
Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up
Unit.

Rel lever is in wrong position.

Rel lever is in wrong position.
Cause
The Release Lever is up.

Rewinding error.

Rewinding error.
There is some foreign object near the Media Take-up Unit
sensor and the roll cannot be detected.
The Media Take-up Unit sensor is soiled and the roll cannot
be detected.
The roll is out of range of detection by the Media Take-up
Unit sensor.
A paper jam has occurred and the roll cannot be rewound.
The Media Take-up Unit sensor is damaged.
*1: Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to stop, set Skip Take-
Up Err to On. However, note that this error may cause paper jams and affect the printing quality.
Basic Guide
4.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press
the OK button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Rolls in the Printer.")
1.
Lift the Top Cover and remove the foreign object.
2.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press
the OK button.
Printing will resume, starting from the page on which the error occurred.
Use the printer only where the recommended environmental conditions for the paper are met. Note that
various environmental conditions are recommended for various types of paper. For details on the recom-
mended environmental conditions, see the Paper Reference Guide.
(See "Paper Reference Guide.")
1.
Specify Manual as the cutting method and use scissors or a cutting tool to cut the roll.
(See "Specifying the Cutting Method for Rolls.")
For information about paper that is compatible with automatic cutting, see the Paper Reference Guide.
(See "Paper Reference Guide.")
2.
Lift the Release Lever and remove the paper.
Contact your Canon dealer for assistance.
Cause
Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.
Cause
Corrective Action
→
P.11
→
User's Guide
Canceling manual advancing.
(See "Feeding Roll Paper Manually.")
Canceling manual advancing.
Corrective Action
Remove the foreign object near the sensor.
Wipe the sensor with a dry cloth to clean it.
Reload the roll.
Press the OK button to clear the error.
(See "Loading Rolls in the Printer.")
(See "Loading the Rewind Spool on the Media Take-up Unit.")
→
User's Guide
Remove the paper from the Media Take-up Unit.
Press the OK button to clear the error.
Contact your Canon dealer for assistance.
End of paper feed.
Corrective Action
→
Corrective Action
→
P.11
User's Guide
139