End Of Paper Feed; Rel Lever Is In Wrong Position; Rewinding Error; Media Take-Up Unit Ready - Canon imagePROGRAF iPF815 User Manual

Error Message >
The Cutter Unit stops in
the middle of cutting.
In other cases, the Cutter
Unit may be damaged.

End of paper feed.

You are pressing the ▲ button on the Control Panel and trying to rewind the roll to the edge.
Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up Unit.

Rel lever is in wrong position.

Cause
The Release Lever is up.

Rewinding error.

There is some foreign object near the Media Take-up Unit sensor
and the roll cannot be detected.
The Media Take-up Unit sensor is soiled and the roll cannot be de-
tected.
The roll is out of range of detection by the Media Take-up Unit sen-
sor.
13
The Media Take-up Unit sensor is damaged.
A paper jam has occurred and the roll cannot be rewound.
*Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to
stop, set Skip Take-Up Err to On.
902

Media take-up unit ready.

The Take-up Reel setting in the printer MAIN MENU
was changed from Enable to Disable, but a print job was
received before the roll was removed.
End of paper feed.
Messages regarding paper >
Cause
(See "Specifying the Cutting Method for Rolls.")
Contact your Canon dealer for assistance.
Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.
Cause
Cause
Corrective Action
Cause
Corrective Action
Remove the foreign object near the sensor.
Wipe the sensor with a dry cloth to clean it.
Reload the roll.
(See "Loading Rolls in the Printer.")
Contact your Canon dealer for assistance.
Remove the paper from the Media Take-up Unit.
Press the Online button to clear the error.
Press the Stop button and stop printing.
The mode switches from take-up mode to regular mode af-
ter you change the Take-up Reel setting in the MAIN
MENU from Enable to Disable and lift the Release Lever,
or after you execute Paper Cutting.
→P.642
Corrective Action
Release the ▲ button.
Release the ▲ button.
Corrective Action
→P.628
Corrective Action
iPF815