Setting1 Target - NEC Express 5800 User Manual

ufip=/resource1
ufip=/resource1/nic1
ufip=/maintenance1/
nic1

setting1 target

Below is the properties for the target.
Timeout :
Specify the time of the session timeout.
If there is no key operation with pressing Enter key by operator for the specified time, it
logouts automatically and close SMASH-CLP. If "0" is specified, the time is unlimited.
・ Example (set the time for 1200 seconds, 20 minutes)
-> set timeout=1200
oemnec_cputhrottle=00
oemnec_cputhrottle_current=00
Guid=3F2504E0-4F89-11D3-9A0C-AABBCCD
DEEFF
ipaddress=192.168.1.127
subnetmask=255.255.255.0
usedhcp=0
committed=1
macaddress=00:00:4C:02:C7:9B
defaultgatewayaddress=0.0.0.0
ipaddress= 172.16.255.254
subnetmask=255.255.0.0
macaddress=00:00:4C:88:88:88
IMPORTANT:
•Don't use set command which changes the MAC address
because it might cause malfunction of the management
firmware.
IMPORTANT:
•The GUID is big-endian.
IMPORTANT:
•It is possible to set some targets for the default gateway
address. However, the final setting is valid. Only one default
gateway can be existed for the management firmware.
IMPORTANT:
•The setting is valid even after reset of the management
firmware. This setting is saved and restored as SG information.
•The default setting is 500 seconds (about 8 minutes).
551
Display DeviceGUID of the
resource
Display and Set the
resource network
Display and Set the
maintenance network