About Smash-Clp; Operation; General Description - NEC Express 5800 User Manual

SMASH-CLP

About SMASH-CLP

Using SMASH-CLP command line interface,some functions such as below are supported
* Power On/OFF the system
* Display the system information and status
* Set the network
* SOL
SMASH-CLP is command line protocol interface specification defined by DMFT,Distributed
Management Task Force.
The management firmware supports SMASH-CLP version 1.0(DSP0214).

Operation

General description

Connect to the network when using SMASH-CLP. Set the same IP address as set in
EXPRESSSOPE® Monitor or Web Console for the network addres of the terminal software.
SMASH-CLP is a kind of shell program and is not divided in some functions such as Web
Console. So the same SMASH-CLP program is started up If any IP address is used to connect.
The figure below shows the connection from the terminal software(Tera Term) to management
firmware and SMASH-CLP is started up on it.
523