Relocation - NEC Express 5800 User Manual

Hardware

Relocation

Unmount the server from the rack and relocate it by following the procedure below.
Important
1. Refer to "Installation" to unmount the server or rail assembly from the rack.
2. Relocate the server by placing it in the package box or bag that contained the server at the time
of purchase to avoid impact or oscillating. Relocate it carefully when there is no package box or
bag.
3. Refer to "Installation" to mount the server or rail assembly.
4. Refer to "Connection" to connect peripherals.
WARNING
● Contact the distributor from which you purchased or maintenance
service company for extensive work such as floor layout change.
Observe the following instructions to use the server safely. ● Back up your important data stored in the hard disk drive.
There are risks of death or serious personal injury.
● Relocate the server carefully so as not to cause impact on a hard
Refer to descriptions after page iii for details.
disk drive when the hard disk drive is installed.
● Do not disassemble, repair, or alter the server improperly.
● Do not remove the lithium battery.
● Disconnect the power plug when handling the server
CAUTION
Observe the following instructions to use the server safely.
There are risks of fire, personal injury, or property damage.
Refer to descriptions after page iii for details.
● Ensure to use a lifter to lift the server and support the bottom of the
server firmly to install or relocate it. If there is no lifter, carrying the server
by less than 4 persons may cause backache.
● Do not install the server in other than the location specified.
● Do not mount the server to the rack when the rack is unstable.
● Do not mount or unmount interface cables while the power is ON.
158
.