Upgrading Your Server - NEC Express 5800 User Manual

Express5800 series

Hide thumbs Also See for Express 5800:

Table of Contents

Upgrading Your Server

This chapter describes internal optional devices available for the server, procedures for install or

removing such optional devices, and notes on using them.

● Optional devices described in this chapter may be installed or

removed by any user. However, NEC does not assume any

liability for damage to optional devices or the server or

malfunctions of the server resulted from installation by the user.

NEC recommends you ask your service representative for

installing or removing any optional devices.

● Make sure to use only optional devices and cables authorized by

NEC. Repair of the server due to malfunctions, failures, or

damage resulted from installing inappropriate devices or cables

will be charged.

● Make sure to uodate the system when you made any changes to

the hardware configuration.

● It is required to set the maintenance mode to prevent Alert

Report during the operation when mounting optional

products/replacing parts. Clear the maintenance mode setting

after the operations. The maintenance mode can be set and

cleared from EXPRESSSCOPE Monitor or Web Console.

● Ensure to clear the maintenance mode after the operations. In

case it is not cleared, this setting is cleared automatically 180

minutes after the setting.

However, report is sustained if you are under contract for the

maintenance of Report Service. Note that a failure occurred

before the setting is cleared automatically is not reported if the

maintenance mode is not cleared after the operation.

Show Quick Links

Table of Contents