NEC Express 5800 User Manual page 709

Express5800 series

Hide thumbs Also See for Express 5800:

Table of Contents

Appendix C. Settings for each OS

When installing and booting OS, BIOS settings are needed to be changed from the default settings

depending on the OS.Refer to chapter 2 "Hardware" – "BIOS Setup" for BIOS settings details.

The latest information of supported OS is shown in following URL

http://www.58support.nec.co.jp/global/download/index.html

BIOSsettings

Configuration

Hyper-threading

Execute Disable

(Note 1) Select "BIOS SETUP Menu -> Advanced -> OS Control", it appears.

(Note 2) Select "BIOS SETUP Menu -> Advanced -> PCI Subsystem Settings", it appears.

(Note 3) Select "BIOS SETUP Menu -> Advanced -> PCI Subsystem Settings -> Slot Configuration",

(Note 4) Select "BIOS SETUP Menu -> Advanced -> CPU Configuration", it appears.

(Note 5) If x2APIC parameter is Enabled, set to Type2. If x2APIC parameter is Disabled, set to

(Note 6) PCI-Express slot 1 and 14 are Enabled. Others are Disabled.

(Note 7) If NE3108-003, 4ch 1000Base-T, is configured in a PCI slot, change OPROM setting for the

PCI slot in which the 1000Base-T card is configured, to Enabled.

(Note 8) If using A1080a-E model and the Enable Core Count in the "System Web Console -> Core

Status" menu is more than 32, set to Disabled.

(Note 9) If using A1080a-E model(Xeon E7 series inside) and the one or more in PMM#5/6/7/8 are

mounted and enabled, set to Enabled. Others are Disabled.

(Note 10) If Xeon 7500 processors are mounted, set to Disabled.

(Note 11) If Service Pack 1 is not installed or in case of installing or using Hyper-V, set to Disabled.

(Note 12) If x2APIC parameter is Enabled, set to Type3. If x2APIC parameter is Disabled, set to

(Note 13) If using A1080a-E model(Xeon E7 series inside) and the one or more in PMM#5/6/7/8 are

mounted and enabled, set to Enabled. Others are arbitrary (Factory default is

recommended).

Show Quick Links

Table of Contents

Troubleshooting