Table of Contents
Advertisement
Disconnect Mode Option
Disconnect when Modem Control In is not asserted
Ignore Modem Control In
Telnet Com Port Cntrl and terminal type setup
Channel (port) password
Hard disconnect
Disable hard disconnect
State LED off with connection
Disconnect with EOT (^D)
(1) The Telnet Com Port Control feature is used in conjunction with Com Port Redirector. The unit
sends the Terminal Type upon an outgoing connection.
(2) A password is required for a connection to the serial port from the network.
(3) The TCP connection closes even if the remote site does not acknowledge the disconnection.
(4) When there is a network connection to or from the serial port, the state LED turns off instead of
blinking.
(5) When Ctrl+D or Hex 04 is detected, the connection is dropped. Both Telnet Com Port Cntrl and
Disconnect with EOT must be enabled for Disconnect with EOT to function properly. Ctrl+D is only
detected going from the serial port to the network.
(6) When Modem Control In transitions from a high state to a low state, the network connection to or
from the serial port drops.
Flush Mode (Buffer Flushing)
Using this parameter, you can control line handling and network buffers with
connection startup and disconnect.
You can also select between two different packing algorithms.
Note:
All bit positions in the table that are blank represent "don't care" bits,
for that particular option, which can be set to either a 0 or 1 value.
Function
Input Buffer (Serial to Network)
Clear with a connection initiated from the device to the network
Clear with a connection initiated from the network to the device
Clear when the network connection to or from the device is disconnected
Output Buffer (Network to Serial)
Clear with a connection initiated from the device to the network
Clear with a connection initiated from the network to the device
Clear when the network connection to or from the device is disconnected
Alternate Packing Algorithm (Pack Control)
Enable
XPort Direct+ User Guide
Table 7-8. Disconnect Mode Options
(2)
(3)
(4)
(5)
FlushMode ( 0) ? _
Table 7-9. Flush Mode Options
7: Setup Mode: Channel Configuration
7
6
5
4
(6)
1
0
(1)
1
1
1
7
6
1
1
3
2
1
0
0
1
1
5
4
3
2
1
0
1
1
1
1
1
51
Advertisement
Table of Contents
