Table of Contents
Advertisement
Flow
Flow control sets the local handshaking method for stopping serial input/output.
Use the following table to select flow control options:
Port Number
The setting represents the source port number in TCP connections. It is the number
that identifies the channel for remote initiating connections.
The default setting for Port 1 is 10001. The range is 1-65535, except for the following
reserved port numbers:
Warning:
for this setting as incorrect operation may result.
Use Port 0 for the outgoing local port to change with each connection. The port range
is 50,000 to 59,999. Each subsequent connection increments the number by 1 (it
wraps back around to 50,000).
XPort Direct+ User Guide
Table 7-3. Interface Mode Options
I/F Mode Option
7
RS-422/485
RS-485 2-wire
Flow (0) ? _
Table 7-4. Flow Control Options
Flow Control Option
No flow control
XON/XOFF flow control
Hardware handshake with RTS/CTS lines
XON/XOFF pass characters to host
Port No (10001) ? _
Table 7-5. Reserved Port Numbers
Port Numbers
Reserved for
1 – 1024
Reserved (well known ports)
9999
Telnet setup
14000-14009
Reserved for Redirector
30704
Reserved (77F0h)
30718
Reserved (77FEh)
We recommend that you not use the reserved port numbers
7: Setup Mode: Channel Configuration
6
5
4
3
2
1
0
0
1
1
1
Hex
00
01
02
05
42
Advertisement
Table of Contents
