Exiting Setup Mode - Lantronix XPort Direct+ User Manual

3. Reset the XPort Direct+ unit by cycling the unit's power (turning the power off
and back on). Immediately upon resetting the device, enter three lowercase x
characters (xxx).
Note:
the terminal (or emulation) while resetting the unit. You must do this
within three seconds of resetting the XPort Direct+.
At this point, the screen display is the same as when you use a Telnet connection. To
continue, go to step 4 in

Exiting Setup Mode

To exit setup mode:
You have two options:
XPort Direct+ User Guide
The easiest way to enter Setup Mode is to hold down the x key at
Telnet
To save all changes and reboot the device, select option 9 Save and exit
from the Change Setup menu. All values are stored in nonvolatile memory.
To exit the configuration mode without saving any changes or rebooting.
select option 8 Exit without save from the Change Setup menu.
5: Configuration via Telnet or Serial Port (Setup Mode)
Connection, above.
36