Serial Port Connection; Exiting Setup Mode; Figure 6-1. Mac Address; Figure 6-2. Setup Menu Options - Lantronix UDS1100 User Manual

Lantronix - device server with poe
Hide thumbs Also See for UDS1100:
Table of Contents

Advertisement

3. To enter Setup Mode, press Enter within 5 seconds. The configuration settings
display, followed by the Change Setup menu.
4. Select an option on the menu by entering the number of the option in the
Your choice? field and pressing Enter.
5. To enter a value for a parameter, type the value and press Enter, or to confirm a
current value, just press Enter.
6. When you are finished, save the new configuration (option 9). The unit reboots.

Serial Port Connection

To configure the unit through a serial connection:
1. Connect a console terminal or PC running a terminal emulation program to your unit's
serial port. The default serial port settings are 9600 baud, 8 bits, no parity, 1-stop
bit, no-flow control.
2. Reset the UDS1100 unit by cycling the unit's power (turning the power off and back
on). Immediately upon resetting the device, enter three lowercase x characters (xxx).
Note:
terminal (or emulation) while resetting the unit. You must do this within
three seconds of resetting the UDS1100.
At this point, the screen display is the same as when you use a Telnet connection. To
continue, go to step 3 in

Exiting Setup Mode

Two options through which to exit setup mode:
To save all changes and reboot the device, select option 9 Save and exit from the
Change Setup menu. All values are stored in nonvolatile memory.
To exit the configuration mode without saving any changes or rebooting. select
option 8 Exit without save from the Change Setup menu.
UDS1100 User Guide

Figure 6-1. MAC Address

*** Lantronix UDS1100 Device Server ***
MAC address 00204A9B0D13
Software version V6.8.0.2 (120710)
Press Enter for Setup Mode

Figure 6-2. Setup Menu Options

Change Setup:
0 Server
1 Channel 1
5 Expert
6 Security
7 Defaults
8 Exit without save
9 Save and exit
The easiest way to enter Setup Mode is to hold down the x key at the
Telnet
6: Configuration via Telnet or Serial Port (Setup Mode)
Your choice? _
Connection, above.
37

Advertisement

Table of Contents
loading

Table of Contents