Changing Print Job Settings - Oce Arizona T220UV User Manual

You can either:
Press ACCEPT and the display advances to the Place Media menu ( see "Place Media
Menu" on page 56), the last step prior to actual printing.
Press + or - and the display will advance to the New Media Thickness display, as
indicated below.

Changing Print Job Settings

3.2.1
The following three settings may be altered if the operator chooses to change them when
the print information for a particular job is displayed:
• Media Thickness
• UV Power Setting
• Horizontal and Vertical Offsets
Media Thickness
Once it is set, the media thickness value is retained by the printer until it is re-set.
Therefore if you measure the thickness of a particular batch of media, there is no need
to change this unless you switch to a different media. As a precaution against damaging
the printheads, there is a media touch rotary switch located on the lead edge of the
carriage used to detect any obstacles higher than the media on the table. If anything on
the table is sitting too high, including the media, the media touch rotary switch will cause
the gantry to stop and the control panel will cancel the current print job and alert the
operator to the problem.
ODGS recommends that the operator measure the media thickness with a set of
calipers.This ensures optimum conditions for achieving the best possible print quality by
placing the print nozzles at the optimal height above the media. Since the clearance
between the media and the print heads is only 2mm (0.08 in.), altering the clearance has
a negative impact on the bi-directional alignment.
Caution:
media supply box may not be reliable. Always measure the media to
be sure of the correct height.
6/2/04
a) Press + or - key if you want to change media thickness, UV lamp power,
horizontal or vertical image offsets, or print job parameters (if Parameters
is enabled); or
b) Press ACCEPT to continue the print job.
In some cases media thickness specifications listed on the
Printing a Job |
3-53