Mounting The Realpresence Collaboration Server (Rmx) 4000 In A Rack; Rack Mount Preparations - Polycom RealPresence RMX 4000 Hardware Manual

3. Push the card into the slot until the ejector levers touch the front edge of the card cage.
4. Push the ejector levers to their fully closed position.
5. Tighten the captive screws on each side of the rear panel of the card, securing the RTM ISDN
card to the MCU.
When a new ISDN card is installed you are required to do the followings:
▪ Update your license.
For more information, see the RealPresence Collaboration Server (RMX) 1800/2000/4000/Virtual
Edition Getting Started Guide, First Entry Power-up and Configuration.
▪ In the ISDN Network Services, define a New ISDN Network Service.
For more information, see the RealPresence Collaboration Server (RMX) 1800/2000/4000/Virtual
Edition Administrator Guide, Adding/Modifying ISDN Network Services.
Mounting the RealPresence Collaboration Server
(RMX) 4000 in a Rack
Perform the following steps to mount the RealPresence Collaboration Server (RMX) 4000 in a Rack.

Rack Mount Preparations

• Depending on the rack installed in your site, you may need to remove the handles if they are
attached to the RealPresence Collaboration Server (RMX) 4000.
• If the opening in the rack that is allocated to the RealPresence Collaboration Server (RMX) 4000 is
exactly 6U, the feet must be removed from the RealPresence Collaboration Server (RMX) 4000 to
install it in the rack.
Polycom, Inc.
RMX 4000 Installation
23