Installation - Datalogic MAGELLAN 8200 Product Reference Manual

Installation

Figure 2-19. Removing the All Weighs™ Platter
a
Product Reference Guide
1. Make sure that all cables are firmly attached (except that the AC/
DC power supply should not be connected to the AC outlet yet).
2. Remove the All-Weighs™ platter to gain access to the lift han-
dles. Simply grasp the top edge of the platter, tilt slightly and lift
off vertically (see Figure 2-19a). If the top edge is blocked, insert a
coin into one or both indentations along either side of the platter
and pry gently to lift the platter edge. Grasp the raised sides and
carefully lift the platter off as shown in Figure 2-19b.
3. Rotate the lift handles to the vertical position and pick the unit
up using fingers hooked into both handles. Tip: To keep the unit
level during installation, spread the remaining fingers to steady
the unit as shown in Figure 2-20b. DO NOT attempt to lift the
unit using the plastic edges, scale frame, or any features other
than the lift handles.
4. Lower the unit into the counter opening, ensuring that none of
the cables are pinched, pierced or crimped.
(Obstruction)
Coin
b
2-31