Table of Contents
Advertisement
GUIDE TO INSTALLATION
SERIAL INTERFACE MODELS
The following can be used as a checklist to verify all the necessary steps for complete
installation of the DX8200 scanner.
1. Read all information in the section Safety Precautions at the beginning of this manual.
2. Correctly configure, position and mount the scanner for barcode reading according to the
information in paragraphs 2.2 including all applicable sub-paragraphs, 2.3, and 4.4.
3. Provide correct system cabling according to the signals necessary (see all applicable sub-
paragraphs under 2.4 and 2.5).
4. Install the Configuration Disk and configure the software parameters from a host computer
using one of the following methods:
• WinHost interface utility program. For more details refer to the section "DX8200
Configuration" in the WinHost Help On Line.
• Host Mode programming procedure by ESC sequences via the serial interface. For
more details refer to the hDX8200 file in the DX8200 directory.
Fine tuning of the scanner position for barcode reading can be
accomplished using the Test Mode as described in WinHost.
NOTE
The installation is now complete.
BUS INTERFACE MODELS
The following can be used as a checklist to verify all the necessary steps for complete
installation of the DX8200 scanner.
1. Read all information in the section Safety Precautions at the beginning of this manual.
2. Correctly position and mount the scanner for barcode reading according to the
information in paragraphs 3.2, and 4.4.
3. Provide correct system cabling according to the signals necessary (see all applicable
sub-paragraphs under 3.3 and 3.4).
4. Configure your DX8200 by means of the SC8000 unit.
Fine tuning of the scanner position for barcode reading can be
accomplished by performing a test through the SC8000 unit.
NOTE
The installation is now complete.
v
Advertisement
Table of Contents
