Datalogic MAGELLAN 8200 Product Reference Manual page 382

PRESS
DURATION
Momentary (when Wakes scanner from Sleep
scanner is asleep) Mode
Momentary (when
Increments volume
scanner is awake)
Hold, then release
when the beeper Increments tone
sounds
5 Seconds
Scanner Diagnostics Mode
10 Seconds
Resets Scanner
a. By standard default, this function is normally disabled to prevent accidental activation by users.
b. Users should not perform scanner resets except under the direction of systems support personnel.
A-4
Table A-2. Volume/Tone Push Button Functions
FUNCTION
Alternatively, the scanner can be awakened by:
- Moving an object through the scan zone.
- A weight change on the scale.
- Changing the ambient light.
- Scanning with an attached auxiliary scanner.
Press the push button momentarily to increase speaker
volume. When the loudest volume is reached, a
repeated press of the push button cycles volume back
to the lowest setting, then volume increases on subse-
quent press(es). Five volume levels are available.
Press the push button for approximately 2 seconds,
then release. Each time this is done, the beeper will
sound at one of three tones. Stop when the desired
tone (high, medium or low) is sounded.
This mode allows system support personnel to trouble-
shoot problems with the scanner. Upon entering Scan-
ner Diagnostic Mode, view the 7-segment display to
view Interface Type, Bootloader Version Number, Appli-
a
cation Version Number and Configuration File Number.
This mode is used to determine if a scanner can read
bar codes. Press the button for eight seconds or cycle
power to exit Scanner Diagnostics Mode and reset the
scanner.
b
Only system support personnel should perform a reset.
®
Magellan 8100/8100
COMMENT
Ω /
and 8200 8200
Ω
Scanner