Led And Beeper Indicators; If You Make A Mistake; Return To Factory Settings - Datalogic MAGELLAN 8200 Product Reference Manual

LED and Beeper Indicators

If You Make a Mistake...

Return to Factory Settings

Use this bar code with caution, since it will reset ALL features that may have
been programmed since the scanner's installation.
CAUTION
DO NOT scan the SWITCH bar code before and after scanning this bar code.
NOTE
Product Reference Guide
The scanner provides a set of indicators that verify/announce the various
scanner functions.
If, during a programming session, you find that you are unsure of the
scanner's settings or wish to reset the scanner's configuration, use the
Return to Factory Settings label below to return the scanner's configura-
tion to the factory settings. Scanning this label will also reset any changes
made during previous programming sessions.
Scan this bar code to return the scanner to the default settings configured
at the factory for the currently active interface. This bar code is typically
used to return the scanner to a "known" operating state when the present
programming status is not known, faulty, or suspect.
RETURN TO FACTORY SETTINGS
6-9