Indicator Leds - Datalogic MAGELLAN 8200 Product Reference Manual

Indicator LEDs

LED
INDICATION
Yellow LED on steady
a
Scale at Zero
a
Green LED on steady and dim
Scanner Active
(Normal Mode)
Good Read
Green LED - bright flash
a
Indication
Program Mode Green LED - Continuous flashing
Indication
Sleep Mode
Green LED blinks at a 2-second rate
Indication
1-second off, 1/10-second on
Host Disabled
Audible low tone 3 seconds.
Field Replace-
Alternating Green/Yellow LED flashes
able Unit (FRU)
continuously.
Warning (Error
Mode)
Green LED flashes a coded
sequence in concert with the speaker.
FRU Indication
a. Certain functions of the Green and Yellow LEDs are selectable to be enabled or disabled. Your scanner may
not be programmed to display all indications.
A-2
The green LED indicates scanner status, and the yellow LED is primarily
used to show scale status as described in Table A-1 below:
Table A-1. Green and Yellow LED Functions
DURATION
®
Magellan 8100/8100
COMMENT
The scale is at rest and reads zero weight. The
scale is ready to weigh.
The scanner is ready for operation. Scanning is
immediately available.
Indicates a bar code has been read and decoded.
Indicates the scanner is in Label Programming
Mode. Cycle power to exit Programming Mode.
The scanner motor and/or laser have automati-
cally switched off and the unit has entered Sleep
Mode due to extended inactivity.
Host has disabled scanning.
Serves notice that a fatal FRU failure has been
detected. Consult Error Codes in Section 4 for
more details. If a low tone is heard, but continuous
flashing is not observed, the scanner can still func-
tion in a limited capacity. Call systems support for
service in either case.
Occurs ONLY upon Volume/Tone button push fol-
lowing a FRU warning. Enables service techni-
cians to identify FRU failures.
Ω
and 8200
/ Ω
8200 Scanner