Error Codes - Datalogic MAGELLAN 8200 Product Reference Manual

Error Codes

When troubleshooting, always remember to check all cable connections
first before proceeding with other problem isolation steps.
Product Reference Guide
If an error is detected, the scanner will sound a long low tone (for three
seconds) and alternately flash its LEDs, indicating a failure. When this
occurs, press the Volume/Tone Push button to display the error code on
the 7-segment display (refer to Figure 4-1). The scanner will also sound a
series of beeps corresponding to the error code. The table below describes
what these codes mean and what action should be taken for each.
4-3