One-Step Patch Installation - HP 4800G Series Configuration Manual

Configuration Prerequisites
Patches are released per device model type. Before patching the system, you need to save the
appropriate patch files to the storage media of the device using FTP or TFTP. When saving the patch
files, note that:
The patch files match the device model and software version. If they are not matched, the hotfixing
operation will fail.
Name the patch file properly. Otherwise, the system cannot locate the patch file and the hotfixing
operation will fail. The name is in the format of "patch_PATCH-FLAG suffix.bin". The
PATCH-FLAG is pre-defined and support for the PATCH-FLAG depends on device model. The first
three characters of the version item (using the display patch information command) represent
the PATCH-FLAG suffix. The system searches the root directory of the storage medium (flash by
default) for patch files based on the PATCH-FLAG. If there is a match, the system loads patches to
or install them on the memory patch area.
Table 1-1 describes the default patch name for device.
Table 1-1 Default patch names for device
Product
4800G
The loading and installation are performed on all member devices. Before these operations, save the
same patch files to the root directories in the storage media of all member devices.

One-Step Patch Installation

You can use the patch install command to install patches in one step. After you execute the command,
the system displays the message "Do you want to continue running patches after reboot? [Y/N]:".
Entering y or Y: All the specified patches are installed, and turn to the RUNNING state from IDLE.
This equals execution of the commands patch location, patch load, patch active, and patch run.
The patches remain RUNNING after system reboot.
Entering n or N: All the specified patches are installed and turn to the ACTIVE state from IDLE. This
equals execution of the commands patch location, patch load and patch active. The patches
turn to the DEACTIVE state after system reboot.
Follow these steps to install the patches in one step:
To do...
Enter system view
Install the patches in one step
PATCH-FLAG
PATCH-XXX
Use the command...
system-view
patch install patch-location
1-5
Default patch name
patch_xxx.bin
—
Required
Remarks