Snmp Configuration Synchronization Function - HP 4800G Series Configuration Manual

To do...
Configure the NM interface of
the management device
To isolate management protocol packets of a cluster from packets outside the cluster, you are
recommended to configure to prohibit packets from the management VLAN from passing the ports that
connect the management device with the devices outside the cluster and configure the NM interface for
the management device.

SNMP Configuration Synchronization Function

SNMP configuration synchronization function facilitates management of a cluster, with which you can
perform SNMP-related configurations on the management device and synchronize them to the member
devices on the whitelist. This operation is equal to configuring multiple member devices at one time,
simplifying the configuration process. Follow these steps to configure the SNMP configuration
synchronization function:
To do...
Enter system view
Enter cluster view
Configure the SNMP
community name
shared by a cluster
Configure the SNMPv3
group shared by a
cluster
Create or update
information of the MIB
view shared by a cluster
Add a user for the
SNMPv3 group shared
by a cluster
Use the command...
nm-interface vlan-interface
vlan-interface-id
Use the command...
system-view
cluster
cluster-snmp-agent community
{ read | write } community-name
[ mib-view view-name ]
cluster-snmp-agent group v3
group-name [ authentication |
privacy ] [ read-view read-view ]
[ write-view write-view ] [ notify-view
notify-view ]
cluster-snmp-agent mib-view
included view-name oid-tree
cluster-snmp-agent usm-user v3
user-name group-name
[ authentication-mode { md5 | sha }
auth-password ] [ privacy-mode
des56 priv-password ]
1-17
Remarks
Optional
Remarks
—
—
Required
Required
Required
By default, the name of the MIB
view shared by a cluster is
ViewDefault and a cluster can
access the ISO subtree.
Required