Ftp Client Configuration Example - HP 4800G Series Configuration Manual

FTP Client Configuration Example

Single Device Upgrade
Network requirements
As shown in
are 10.2.1.1/16 and 10.1.1.1/16 respectively. An available route exists between Device and PC.
Device downloads a startup file from PC for device upgrade, and uploads the configuration file to
PC for backup.
On PC, an FTP user account has been created for the FTP client, with the username being abc
and the password being pwd.
Figure 2-2 Network diagram for FTPing a startup file from an FTP server
Configuration procedure
If the available memory space of the device is not enough, use the fixdisk command to clear the
memory or use the delete /unreserved file-url command to delete the files not in use and then perform
the following operations.
# Log in to the server through FTP.
<Sysname> ftp 10.1.1.1
Trying 10.1.1.1
Connected to 10.1.1.1
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(10.1.1.1:(none)):abc
331 Give me your password, please
Password:
230 Logged in successfully
# Set the file transmission mode to binary to transmit startup file.
[ftp] binary
200 Type set to I.
# Download the startup file newest.bin from PC to Device.
[ftp] get newest.bin
# Upload the configuration file config.cfg of Device to the server for backup.
[ftp] ascii
Figure 2-2, use Device as an FTP client and PC as the FTP server. Their IP addresses
2-6