Configuring Ntp Authentication - HP 4800G Series Configuration Manual

peer: full access. This level of right permits the peer devices to perform synchronization and control
query to the local device and also permits the local device to synchronize its clock to that of a peer
device.
From the highest NTP service access-control right to the lowest one are peer, server,
synchronization, and query. When a device receives an NTP request, it will perform an
access-control right match and will use the first matched right.
Configuration Prerequisites
Prior to configuring the NTP service access-control right to the local device, you need to create and
configure an ACL associated with the access-control right. For the configuration of ACL, refer to ACL
Configuration in the Security Volume.
Configuration Procedure
Follow these steps to configure the NTP service access-control right to the local device:
To do...
Enter system view
Configure the NTP service
access-control right for a peer
device to access the local device
The access-control right mechanism provides only a minimum degree of security protection for the
system running NTP. A more secure method is identity authentication.

Configuring NTP Authentication

The NTP authentication feature should be enabled for a system running NTP in a network where there
is a high security demand. This feature enhances the network security by means of client-server key
authentication, which prohibits a client from synchronizing with a device that has failed authentication.
Configuration Prerequisites
The configuration of NTP authentication involves configuration tasks to be implemented on the client
and on the server.
When configuring the NTP authentication feature, pay attention to the following principles:
For all synchronization modes, when you enable the NTP authentication feature, you should
configure an authentication key and specify it as a trusted key. Namely, the ntp-service
authentication enable command must work together with the ntp-service authentication-keyid
command and the ntp-service reliable authentication-keyid command. Otherwise, the NTP
authentication function cannot be normally enabled.
For the client/server mode or symmetric mode, you need to associate the specified authentication
key on the client (symmetric-active peer if in the symmetric peer mode) with the corresponding
Use the command...
system-view
ntp-service access { peer |
query | server |
synchronization } acl-number
1-12
Remarks
—
Required
peer by default