Cli Features; Online Help - H3C S5100-SI Operation Manual

View
HWTACACS
view
PoE profile
view
Smart link
group view
Monitor link
group view
Port-group
view
QinQ view
The shortcut key <Ctrl+Z> is equivalent to the return command.

CLI Features

Online Help

When configuring the switch, you can use the online help to get related help information. The CLI
provides two types of online help: complete and partial.
Complete online help
1) Enter a question mark (?) in any view on your terminal to display all the commands available in the
view and their brief descriptions. The following takes user view as an example.
<Sysname> ?
Available operation
Configure
HWTACACS
parameters
Configure PoE profile
parameters
Only S5100-PWR-EI
series switches
provide this view
Configure smart link
group parameters
Configure monitor link
group parameters
Configure port-group
parameters
Only S5100-EI series
switches provide this
view
Configure QinQ
parameters
Only S5100-EI series
Ethernet switches
provide this view
Prompt example Enter method
Execute the
[Sysname-hwtac hwtacacs scheme
acs-a123] command in
system view.
Execute the
[Sysname-poe-pr poe-profile
ofile-a123] command in
system view.
Execute the
[Sysname-smlk-g smart-link group
roup1] command in
system view.
Execute the
[Sysname-mtlk-g monitor-link
roup1] group command in
system view.
Execute the
[Sysname-port-gr port-group
oup-1] command in
system view.
Execute the
vlan-vpn vid
command in
GigabitEthernet
[Sysname-Gigabi
port view.
tEthernet1/0/1-vi
d-20]
The vlan-vpn
enable command
should be first
executed.
5-7
Quit method
Execute the
quit command
to return to
GigabitEthernet
port view.
Execute the
return
command to
return to user
view.