H3C S5100-SI Operation Manual page 490

Operation
Configure the device forward
delay of topology collection
requests
Configure the port forward
delay of topology collection
requests
Configure the interval to collect
topology information
periodically
Quit system view
Launch topology information
collection manually
Enabling the cluster function
Table 2-8 Enable the cluster function
Operation
Enter system view
Enable the cluster function
globally
Configuring cluster parameters
The establishment of a cluster and the related configuration can be accomplished in manual mode or
automatic mode, as described below.
1) Establishing a cluster and configuring cluster parameters in manual mode
Table 2-9 Establish a cluster and configure cluster parameters in manual mode
Operation
Enter system view
Specify the management VLAN
Enter cluster view
Configure a IP address pool for
the cluster
Build a cluster
Command
ntdp timer hop-delay time
ntdp timer port-delay time
ntdp timer interval-in-minutes
quit
ntdp explore
Command
system-view
cluster enable
Command
system-view
management-vlan vlan-id
cluster
ip-pool
administrator-ip-address
{ ip-mask | ip-mask-length }
build name
2-11
Description
Optional
By default, the device forward
delay is 200 ms.
Optional
By default, the port forward
delay is 20 ms.
Optional
By default, the topology
collection interval is one
minute.
—
Optional
Description
—
Required
By default, the cluster function
is enabled.
Description
—
Required
By default, VLAN 1 is used as
the management VLAN.
—
Required
Required
name: cluster name.