H3C S5100-SI Operation Manual page 453

The source port, the reflector port, and the remote-probe VLAN are determined.
Layer 2 connectivity is ensured between the source and destination switches over the
remote-probe VLAN.
The direction of the packets to be monitored is determined.
2) Configuration procedure
Table 1-3 Follow these steps to perform configurations on the source switch:
To do...
Enter system view
Create a VLAN and enter
the VLAN view
Configure the current VLAN
as the remote-probe VLAN
Return to system view
Enter the view of the
Ethernet port that connects
to the intermediate switch
or destination switch
Configure the current port
as trunk port
Configure the trunk port to
permit packets from the
remote-probe VLAN
Return to system view
Create a remote source
mirroring group
Configure source port(s) for
the remote source mirroring
group
Configure the reflector port
for the remote source
mirroring group
Configure the remote-probe
VLAN for the remote source
mirroring group
When configuring the source switch, note that:
All ports of a remote source mirroring group are on the same device. Each remote
source mirroring group can be configured with only one reflector port.
The reflector port cannot be a member port of an existing mirroring group, a member
port of an aggregation group, or a port enabled with LACP or STP. It must be an access
Use the command...
system-view
vlan vlan-id
remote-probe vlan enable
quit
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
remote-probe-vlan-id
quit
mirroring-group group-id
remote-source
mirroring-group group-id
mirroring-port
mirroring-port-list { both |
inbound | outbound }
mirroring-group group-id
reflector-port
reflector-port
mirroring-group group-id
remote-probe vlan
remote-probe-vlan-id
1-6
Remarks
—
vlan-id is the ID of the
remote-probe VLAN.
Required
—
—
Required
By default, the port type is
Access.
Required
—
Required
Required
Required
Required