Applying A Qos Profile - H3C S5100-SI Operation Manual

Configuration procedure
Follow these steps to configure a QoS profile:
To do...
Enter system view
Create a QoS profile
and enter QoS profile
view
Configure traffic
policing
Configure the packet
filtering action
Configure the priority
marking action

Applying a QoS Profile

You can enable a QoS profile to be dynamically applied or apply it manually.
Configuration prerequisites
To enable a QoS profile to be applied dynamically, make sure 802.1x has been enabled
both globally and on the port, and the authentication mode has been determined. For
information about 802.1x, refer to the 802.1x and System Guard module of this manual.
To apply a QoS profile manually, make sure the port to which the QoS profile is to be
applied has been determined.
The QoS profile to be applied has been determined.
Configuration procedure
Follow these steps to apply a QoS profile dynamically:
To do...
Enter system view
Enter Ethernet port view
Use the command...
system-view
qos-profile profile-name
traffic-limit inbound acl-rule
target-rate [ conform
con-action ] [ exceed
exceed-action ]
[ meter-statistic ]
packet-filter inbound acl-rule
traffic-priority inbound acl-rule
{ dscp dscp-value | cos
cos-value }
Use the command...
system-view
interface interface-type
interface-number
2-3
Remarks
—
Required
If the specified QoS
profile already exists, you
enter the QoS profile view
directly.
Optional
Optional
Refer to the ACL module
of this manual for
information about packet
filtering.
Optional
Remarks
—
—