TRENDnet User's Guide
Installation
Make sure that all devices are powered off before starting installation.
Connect the Power
1
Connect the power adapter to the power port of your access point.
2
Plug the power adapter to a power outlet.
The access point powers up automatically.
DC IN
2.4GHz
PWR
5GHz
LAN
Use only the supplied power adapter. Using other power adapters may cause
ÍNote:
damage to the device.
Connect the Computer
1
Connect one end of the first RJ-45 cable to the Ethernet port of your access point.
2
Connect the other end of the first RJ-45 cable to the PoE switch.
3
Connect one end of the second RJ-45 cable to the PoE switch.
4
Connect the other end of the second RJ-45 cable to the LAN port of your computer.
LAN
2.4GHz
5GHz
LAN
PWR
TEW-821DAP
© Copyright 2015 TRENDnet. All Rights Reserved.
PoE switch
Computer
Check the Connections
To ensure that all devices are properly connected, check the LED indicators on the front
of your access point. For basic installation, the following LED must be lit:
9 Power LED
9 LAN LED
9 2.4G LED
9 5G LED
The lighted LED indicators vary depending on the type of connection that you make. Refer
to
"Front View" on page 6
for more information on LED indicators.
TEW-821DAP
8