Table of Contents
Advertisement
TRENDnet User's Guide
Additional hardware installation
Ground wire
When placing your device out in an open area where lightning strikes can occur, it is
advisable to ground it. This would protect your device from being damage and your
network.
1. Pinch the tab and slide the bottom cover down
2. Remove the screw and insert the grounding wire on the screw.
3. Tighten the screw firmly in place and router the wire alongside the Ethernet cable.
4. Position both wires inside the access hole and the edge of the case, slide the cover
back into place
© Copyright 2015 TRENDnet. All Rights Reserved.
Pole mounting
The access point comes with a pole mounting clamp that allows you to mount the
device to a pole. The weather and outdoor rating of the device is based on upright
position. It is important that the device is always mounted in an upright position.
Note: The mounting clamp supports up to 63mm diameter.
1. Loosen the pole mounting clamp by turn the bolt in of the clamp counter clock
wise
2. Insert one end of the clamp through the back (center section) of the access
point.
3. Align the access point to the pole and tighten up the clamp till the access point
is secured on the pole.
TEW-734APO
58
Advertisement
Table of Contents
