If-Match Ipv6 - HP 6125G Command Reference Manual

Field
Denied
Index
Permit
::/1
ge
Le

if-match ipv6

Syntax
if-match ipv6 { address | next-hop | route-source } { acl acl6-number | prefix-list ipv6-prefix-name }
undo if-match ipv6 { address | next-hop | route-source } [ acl | prefix-list ]
View
Routing policy view
Default level
2: System level
Parameters
address: Matches the destination address of IPv6 routing information.
next-hop: Matches the next hop of IPv6 routing information.
route-source: Matches the source address of IPv6 routing information.
acl acl6-number: Specifies the number of an IPv6 ACL for filtering, in the range of 2000 to 3999 for
address, and 2000 to 2999 for next-hop and route-source.
prefix-list ipv6-prefix-name: Specifies the name of a IPv6 prefix list for filtering, a string of 1 to 19
characters.
Description
Use if-match ipv6 to configure a destination, next hop or source address based match criterion for IPv6
routes.
Use undo if-match ipv6 to remove the match criterion.
The match criterion is not configured by default.
Examples
# Configure node 10 of routing policy policy1 to permit routing information whose next hop address
matches IPv6 prefix list p1.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match ipv6 next-hop prefix-list p1
Description
Number of routes not satisfying the match criterion
Index number of the prefix list
Match mode of the item: permit or deny
IPv6 address and prefix length for matching
greater-equal, the lower prefix length
less-equal, the upper prefix length
360