Rip Default-Route - HP 6125G Command Reference Manual

Description
Use rip bfd enable to enable BFD on the RIP interface.
Use undo rip bfd enable to restore the default and delete the relevant BFD session.
By default, a RIP interface is not enabled with BFD.
BFD echo-mode detection only works for a RIP neighbor one hop away.
Using the undo peer command does not delete the neighbor relationship at once and cannot bring down
the BFD session at once.
Examples
# Enable BFD on RIP interface VLAN-interface 1 1.
<Sysname> system-view
[Sysname] interface vlan-interface 11
[Sysname-Vlan-interface11] rip bfd enable

rip default-route

Syntax
rip default-route { { only | originate } [ cost cost ] | no-originate }
undo rip default-route
View
Interface view
Default level
2: System level
Parameters
only: Advertises only a default route.
originate: Advertises a default route and other routes.
cost: Cost of the default route, in the range of 1 to 15. The default is 1.
no-originate: Advertises routes other than a default route.
Description
Use rip default-route to configure the RIP interface to advertise a default route with the specified metric.
Use undo rip default-route to disable the RIP interface from sending a default route.
By default, a RIP interface can advertise a default route if the RIP process is configured with default route
advertisement.
A RIP router configured to advertise a default route will not receive any default routes from RIP neighbors.
Related commands: default-route.
Examples
# Configure VLAN-interface 10 to advertise only a default route with a metric of 2.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip default-route only cost 2
47