Output-Delay; Peer - HP 6125G Command Reference Manual

RIP runs only on the interfaces attached to the specified network. For an interface not on the specified
network, RIP neither receives/sends routes on it nor forwards interface route through it. You need to
specify the network after enabling RIP to validate RIP on a specific interface.
For a single process, the network 0.0.0.0 command can enable RIP on all interfaces, but the command
is not applicable in case of multi-process.
If a physical interface is attached to multiple networks, you cannot advertise these networks in different
RIP processes.
Examples
# Enable RIP on the interface attached to the network 129.102.0.0.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] network 129.102.0.0

output-delay

Syntax
output-delay time count count
undo output-delay
View
RIP view
Default level
2: System level
Parameters
time: RIP packet sending interval, in milliseconds. It is in the range of 10 to 100.
count: Maximum number of RIP packets sent at each interval. It is in the range of 1 to 20.
Description
Use output-delay to configure the maximum RIP packets that can be sent at the specified interval for all
interfaces under the RIP process.
Use undo output-delay to restore the default.
By default, an interface sends up to three RIP packets every 20 milliseconds.
Examples
# Configure all the interfaces under RIP process 1 to send up to 10 RIP packets every 30 milliseconds.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] output-delay 30 count 10

peer

Syntax
peer ip-address
undo peer ip-address
42