NOTE:
Using the import-route bgp4+ command redistributes only eBGP routes, and using the import-route
bgp4+ allow-ibgp command redistributes both eBGP and iBGP routes.
Description
Use import-route to redistribute routes.
Use undo import-route to disable routes redistribution.
IPv6 OSPFv3 does not redistribute routes from other protocols by default.
Examples
# Configure to redistribute routes from RIPng and specify the type as type 2 and cost as 50.
<Sysname> system-view
[Sysname] ospfv3
[Sysname-ospfv3-1] import-route ripng 10 type 2 cost 50
log-peer-change
Syntax
log-peer-change
undo log-peer-change
View
OSPFv3 view
Default level
2: System level
Parameters
None
Description
Use log-peer-change to enable the logging on neighbor state changes.
Use undo log-peer-change to disable the logging.
With this feature enabled, information about neighbor state changes of the current OSPFv3 process will
display on the configuration terminal.
Examples
# Disable the logging on neighbor state changes of OSPFv3 process 100.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] undo log-peer-change
maximum load-balancing (OSPFv3 view)
Syntax
maximum load-balancing maximum
undo maximum load-balancing
257