Import-Route - HP 6125G Command Reference Manual

View
RIPng view
Default level
2: System level
Parameters
acl6-number: Specifies the number of an ACL to filter incoming routing information, in the range of 2000
to 3999.
ipv6-prefix ipv6-prefix-name: Specifies the name of an IPv6 prefix list to filter incoming routes, in the
range of 1 to 19 characters.
Description
Use filter-policy import to define an inbound route filtering policy. Only routes which match the filtering
policy can be received.
Use undo filter-policy import to disable inbound route filtering.
By default, RIPng does not filter incoming routing information.
If you want to reference an advanced ACL (with a number from 3000 to 3999) in the command, the ACL
should be configured with the rule [ rule-id ] { deny | permit } ipv6 source sour sour-prefix command to
deny/permit a route with the specified destination, or with the rule [ rule-id ] { deny | permit } ipv6 source
sour sour-prefix destination dest dest-prefix command to deny/permit a route with the specified
destination and prefix. The source keyword specifies the destination address of a route and the
destination keyword specifies the prefix of the route (the prefix must be valid; otherwise, the configuration
is ineffective).
Examples
# Reference IPv6 prefix list Filter1 to filter incoming RIPng updates.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100] filter-policy ipv6-prefix Filter1 import
# Configure ACL6 3000 to permit only route 2001::1/128 to pass, and reference ACL6 3000 to filter
incoming RIPng updates.
<Sysname> system-view
[Sysname] acl ipv6 number 3000
[Sysname-acl6-adv-3000] rule 10 permit ipv6 source 2001::1 128 destination
ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff 128
[Sysname-acl6-adv-3000] rule 100 deny ipv6
[Sysname-acl6-adv-3000] quit
[Sysname] ripng 100
[Sysname-ripng-100] filter-policy 3000 import

import-route

Syntax
import-route protocol [ process-id ] [ allow-ibgp ] [ cost cost | route-policy route-policy-name ] *
undo import-route protocol [ process-id ]
216