Apply Local-Preference - HP 6125G Command Reference Manual

View
Routing policy view
Default level
2: System level
Parameters
rt route-target: Sets the route target (RT) extended community attribute, a string of 3 to 21 characters.
A route-target has one of the following forms:
• 16-bit AS number—32-bit self-defined number, for example, 101:3
32-bit IP address—16-bit self-defined number, for example, 192.168.122.15:1
•
32-bit AS number—16-bit self-defined number, for example, 70000:3. The AS number should be
•
no less than 65536.
&<1- 1 6>: Indicates the argument before it can be entered up to 16 times.
additive: Adds the specified attribute to the original RT community attribute.
Description
Use apply extcommunity to apply the specified RT extended community attribute to BGP routes.
Use undo apply extcommunity to remove the clause configuration.
No RT extended community attribute is set for BGP routing information by default.
Examples
# Configure node 10 in permit mode of routing policy policy1: If a BGP route matches AS path list 1, add
the RT extended community attribute 100:2 to the route.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match as-path 1
[Sysname-route-policy] apply extcommunity rt 100:2 additive

apply local-preference

Syntax
apply local-preference preference
undo apply local-preference
View
Routing policy view
Default level
2: System level
Parameters
preference: Local preference for BGP routes, in the range of 0 to 4294967295.
Description
Use apply local-preference to configure the specified local preference for BGP routes.
Use undo apply local-preference to remove the clause configuration.
338