Export Route-Policy - HP 6125G Command Reference Manual

Description
Use domain-id to configure an OSPF domain ID.
Use undo domain-id to restore the default.
By default, the OSPF domain ID is 0.
With no parameter specified, the undo domain-id command deletes the primary domain ID.
Usually, routes injected from PEs are advertised as External-LSAs. However, routes to different
destinations in the same OSPF domain must be advertised as Type-3 LSAs. Therefore, using the same
domain ID is required for an OSPF domain.
Examples
# Configure the OSPF domain ID.
<Sysname> system-view
[Sysname] ospf 100 vpn-instance vpn1
[Sysname-ospf-100] domain-id 234

export route-policy

Syntax
export route-policy route-policy
undo export route-policy
View
VPN instance view
Default level
2: System level
Parameters
route-policy: Name of the export routing policy for the VPN instance, a string of 1 to 63 characters.
Description
Use export route-policy to apply an export routing policy to a VPN instance.
Use undo export route-policy to remove the application.
By default, no policy is applied to filter the routes to be advertised.
You can specify an export routing policy when the VPN route advertisement control provided by the
extended community attributes is not enough. An export routing policy may deny routes that are
permitted by the export target attribute.
Examples
# Apply export routing policy poly-1 to VPN instance vpn1.
<Sysname> system-view
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] export route-policy poly-1
378