Rip; Rip Authentication-Mode - HP 6125G Command Reference Manual

<Sysname> reset rip 100 statistics

rip

Syntax
rip [ process-id ] [ vpn-instance vpn-instance-name ]
undo rip [ process-id ] [ vpn-instance vpn-instance-name ]
View
System view
Default level
2: System level
Parameters
process-id: RIP process ID, in the range of 1 to 65535. The default is 1.
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN. vpn-instance-name is a case-sensitive string
of 1 to 31 characters. If no VPN is specified, the RIP process will run under the public network.
Description
Use rip to create a RIP process and enter RIP view.
Use undo rip to disable a RIP process.
By default, no RIP process runs.
You must create a VPN instance before you apply a RIP process to it. For related configuration, see the
ip vpn-instance command in the MCE Command Reference.
You must enable the RIP process before configuring the global parameters. This limitation is not for
configuration of interface parameters.
The configured interface parameters become invalid after you disable the RIP process.
Examples
# Create a RIP process and enter RIP process view.
<Sysname> system-view
[Sysname] rip
[Sysname-rip-1]

rip authentication-mode

Syntax
rip authentication-mode { md5 { rfc2082 [ cipher ] key-string key-id | rfc2453 [ cipher ] key-string } |
simple [ cipher ] password }
undo rip authentication-mode
View
Interface view
Default level
2: System level
45